Technical Specifications

TECHNICAL DATA
SPC-19
RUST-OLUEM
®
SPECIALTY
CHALKBOARD TINTBASE
1
Form: GDH-339
Rev.: 060221
DESCRIPTION AND USES
Rust-Oleum
®
Specialty Chalkboard Tintbase is an ultra-hard,
scratch resistant finish that allows you to create a unique
writable-erasable surface. Ideal for use on doors, tables,
cabinets, picture frames, flower pots and more. Can be
applied to wood, metal, glass, terra cotta, paperboard and
hardboard. It’s also great for resurfacing ping pong tables.
IMPORTANT: PLEASE SEE PAINT COUNTER TO ADD
COLOR. SHAKE BEFORE AND AFTER TINTING.
PRODUCT
SKU
DESCRIPTION (Quart)
243783
Chalkboard Tintbase
PRODUCT APPLICATION
Use when temperature is between 50°F (10°C) and 90°F
(32°C) and humidity is below 85% to ensure proper drying.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants
by washing the surface with a commercial detergent, or
other suitable cleaning method. Rinse with fresh water and
allow to thoroughly dry. Remove loose paint and rust with a
wire brush or sandpaper. Lightly sand glossy surfaces.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
PRIMING
Use of a Rust-Oleum latex primer provides superior
adhesion and hiding and is especially recommended for bare
wood and metal, paperboard and hardboard. Apply
Chalkboard paint 2 hours after applying primer. After priming
bare wood, sand lightly to smooth out the surface.
APPLICATION
Stir thoroughly. Thinning is not required. In hot, dry
conditions, however, you may thin up to 2-oz. water per
quart to extend dry time. Use a good quality synthetic brush,
1/4”-3/8” nap roller or a foam roller designed to give a
smooth finish. Avoid excessive brushing or rolling. Use light,
even strokes to ensure an even flow and the smoothest
finish. A minimum of 2 coats is required. May require
additional coats over contrasting colors.
DRY & RECOAT
Dry and recoat times are based on 77°F (25°C) – 50%
relative humidity. Allow more time at cooler temperatures. A
minimum of 2 coats is required. May require additional coats
over contrasting colors. Dries to the touch in 30 minutes and
to handle in 2 hours. Fully dry in 2-4 hours. May be recoated
after 4 hours.
CONDITIONING AND USE
After 3 days, the chalkboard finish is ready to use. Before
writing, condition the surface by rubbing the side of a piece
of chalk over the entire surface and erase. This will leave a
coat of chalk dust that will provide the best erasability.
Chalkboard can be wiped clean with a damp cloth. Wait 7
days after painting before wiping it down. Repeat
conditioning step after cleaning.
CLEAN-UP
Clean brush and other application tools immediately with
soap and water.
PROTECT FROM FREEZING.