SDS

Date Printed: 5/15/2015
FIRST AID - SKIN CONTACT: Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation
develops or persists.
FIRST AID - INHALATION: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
Get immediate medical attention. Do NOT use mouth-to-mouth resuscitation. If you experience difficulty in breathing, leave the
area to obtain fresh air. If continued difficulty is experienced, get medical assistance immediately.
FIRST AID - INGESTION: If swallowed, get medical attention. Aspiration hazard: Do not induce vomiting or give anything by
mouth because this material can enter the lungs and cause severe lung damage. Get immediate medical attention.
5. Fire-fighting Measures
EXTINGUISHING MEDIA:
Dry Chemical, Dry Sand, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: Keep containers tightly closed. No unusual fire or explosion hazards noted.
Closed containers may explode when exposed to extreme heat due to buildup of steam. Combustible liquid and vapor.
SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent pressure buildup and possible
autoignition or explosion. Evacuate area and fight fire from a safe distance. Use water spray to keep fire-exposed containers cool.
Containers may explode when heated.
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Dispose of according to local, state (provincial) and federal regulations. Do not incinerate
closed containers. Remove all sources of ignition, ventilate area and remove with inert absorbent and non-sparking tools.
7. Handling and Storage
HANDLING: Wash thoroughly after handling. Wash hands before eating. Follow all MSDS/label precautions even after container is
emptied because it may retain product residues. Avoid breathing fumes, vapors, or mist. Avoid contact with eyes. Remove
contaminated clothing and launder before reuse. Use only with adequate ventilation. Avoid contact with eyes, skin and clothing.
STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Keep away from heat,
sparks, flame and sources of ignition. Keep container closed when not in use. Store in a dry, well ventilated place. Keep container
tightly closed when not in use. Do not store above 120 ° F. Store large quantities in buildings designed and protected for storage of
NFPA Class II combustible liquids. Avoid excess heat.
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Limestone 1317-65-3 30.0
15 mg/m3 (Total
Dust, OSHA)
N.E.
5 mg/m3
(Respirable Dust)
N.E.
Octamethylcyclotetrasiloxane 556-67-2 20.0 N.E. N.E. N.E. N.E.
1-Chloro-4-(Trifluoromethyl)
Benzene
98-56-6 20.0 N.E. N.E. N.E. N.E.
Iron Oxide 1309-37-1 10.0
5 mg/m3
(Respirable Dust,
OSHA)
N.E.
15 mg/m3 (Total
Dust)
N.E.
Hydrous Magnesium Silicate 14807-96-6 10.0
2 mg/m3
(Respirable Dust)
N.E.
20 mppcf (Mineral
Dust <1% Quartz)
N.E.
Mineral Spirits 64742-88-7 5.0 100 ppm N.E. 100 ppm N.E.
Wollastonite 13983-17-0 5.0
15 mg/m3 (Total
Dust)
N.E.
5 mg/m3
(Respirable Dust)
N.E.
Crystalline Silica / Quartz 14808-60-7 1.0
0.025 mg/m3
[Respirable Dust]
N.E.
0.1 mg/m3
[Respirable Dust]
N.E.
Ethylbenzene 100-41-4 1.0 20 ppm 125 ppm 100 ppm N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne
levels below recommended exposure limits. Prevent build-up of vapors by opening all doors and windows to achieve cross-
ventilation.
Page 3 / 7