Technical Specifications
TECHNICAL DATA
SPC-29
SPECIA
LTY
HIGH HEAT U
L
TRA
DESCRIPTION AND USES
High Heat Ultra is a rust preventive enamel designed to provide
deep color and rich sheen to protect indoor and outdoor
high heat applications. This durable semi-gloss finish retains
excellent gloss and color retention after repeated heating. High
Heat sprays withstand temperatures up to 1200ºF (648ºC).
Ideal for the exterior of barbeque grills, wood stoves, radia
tors,
fire pits, fireplace screens, automotive parts, and more.
PRODUCT
APPLICA
TION
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50ºF (10ºC)
and
90ºF (32ºC)
and humidity is below 85% to ensure proper
drying. Priming is not recommended. Do not use on
metal
directly exposed to open flame or in direct contact with food,
such as a grill grate. Avoid application in very windy and dusty
conditions. Cover surrounding area to protect from spray
mist.
SURFACE
PREP
ARA
TION
Remove all dirt, grease, oil, salt and chemical
contaminants
by washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow
to
thoroughly dry. Remove loose paint and rust with
a wire brush
or sandpaper. Previously coated surfaces must be sound and
in good condition. Smooth, hard, or glossy finishes should be
scarified by sanding to create a surface profile. Removal
of
old paint by sanding, scraping or other means may genera
te
dust or fumes that contain lead. LEAD IS TOXIC.
Contact the
U.S.EPA/Lead
Information Hotline at 1-800-424-LEAD or log on
to
www
.epa.gov/lead.
APPLICATION
Sprays
-
Shake can vigorously for one minute after the
mixing
ball begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN.
Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16” from surface and spray in a steady
back-and-
forth motion, slightly overlapping each stroke. Keep the can
the same distance from the surface and x5in motion
while
APPLICATION
(cont.)
spraying.
Apply two or more light coats a few minutes apart
to
avoid drips and runs. Do not use near open
flame.
DRY & RECOAT
TIMES
Dry and recoat times are based on 70ºF and 50% rela
tive
humidity. Allow more time at cooler temperatures. Dries
to touch
in 30 minutes and to handle in 1-2
hours.
Allow paint to dry for
1
hour before heating. Product may emit smoke and harmless odor
.
May recoat within 1 hour or after 48 hours.
CLEAN-UP
Clean valve immediately after
use by turning can upside down and
depressing spray button for 3-5 seconds. Clean-up wet paint
with
xylene or mineral spirits. Properly discard empty container. Do
not burn or place in home trash
compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent
such as mineral spirits. Do not insert any object into can valve
opening.
1