SDS

Date Printed: 4/22/2016
STORAGE: Store in a dry, well ventilated place. Keep container tightly closed when not in use. Keep containers tightly closed.
Isolate from heat, electrical equipment, sparks and open flame. Do not store above 120 ° F. Store large quantities in buildings
designed and protected for storage of NFPA Class II combustible liquids. Keep away from heat, sparks, flame and sources of
ignition. Avoid excess heat. Product should be stored in tightly sealed containers and protected from heat, moisture, and foreign
materials.
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Hydrotreated Light Distillate 64742-47-8 25.0 N.E. N.E. N.E. N.E.
Mineral Spirits 64742-88-7 20.0 N.E. N.E. N.E. N.E.
Aluminum Flake 7429-90-5 10.0 1 mg/m3 N.E. 15 mg/m3 N.E.
Stoddard Solvent 8052-41-3 10.0 100 ppm N.E. 500 ppm N.E.
Xylene (mixed isomers) 1330-20-7 5.0 100 ppm 150 ppm 100 ppm N.E.
Ethylbenzene 100-41-4 1.0 20 ppm N.E. 100 ppm N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne
levels below recommended exposure limits. Prevent build-up of vapors by opening all doors and windows to achieve cross-
ventilation.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must
be followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with an
organic vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to
exceed exposure limits.
Protection provided by air purifying respirators is limited. Use a positive pressure air supplied respirator if there is any potential for
an uncontrolled release, exposure levels are not known, or in any other circumstances where air purifying respirators may not
provide adequate protection.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin
protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
9. Physical and Chemical Properties
Appearance:
Liquid
Physical State:
Liquid
Odor:
Solvent Like
Odor Threshold:
N.E.
Relative Density:
0.973
pH:
N.A.
Freeze Point, °C:
N.D.
Viscosity:
N.D.
Solubility in Water:
Slight
Partition Coefficient, n-
octanol/water:
N.D.
Decompostion Temp., °C:
N.D.
Boiling Range, °C:
135 - 204
Explosive Limits, vol%:
0.9 - 7.0
Flammability:
Supports Combustion
Flash Point, °C:
27
Evaporation Rate:
Slower than Ether
Auto-ignition Temp., °C:
N.D.
Vapor Density:
Heavier than Air
Vapor Pressure:
N.D.
(See "Other information" Section for abbreviation legend)
10. Stability and Reactivity
CONDITIONS TO AVOID: Avoid temperatures above 120°F (49°C). Avoid contact with strong acid and strong bases. Avoid all
possible sources of ignition. Flammable hydrogen gas will evolve when product comes in contact with water or damp air. Heat will
be generated. The amount of heat generated will depend upon the volume of material in contact.
INCOMPATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies.
HAZARDOUS DECOMPOSITION: By open flame, carbon monoxide and carbon dioxide. When heated to decomposition, it emits
acrid smoke and irritating fumes. Contains solvents which may form carbon monoxide, carbon dioxide, and formaldehyde.
Page 3 / 5