Technical Specifications

TECHNICAL DATA
PTUC-05
PAINTER’S TOUCH
®
ULTRA COVER
SATIN METALLIC FINISH
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 877∙385∙8155
www.rustoleum.com
Form: GDJ-1267
Rev.: 013020
PHYSICAL PROPERTIES
ULTRA COVER SATIN METALLIC FINISH
Resin Type
Oil Modified Urethane
Pigment Type
Varies
Solvents
Hydrotreated Light Distillates, Mineral Spirits
Weight
Per Gallon
7.6-8.5 lbs.
Per Liter
0.91-1.02 kg
Solids
By Weight
45.8-60.2%
By Volume
36.4-47.6%
Volatile Organic Compounds
<500 g/l (4.16 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT
(unthinned material)
2.0-4.0 mils
(50-100µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
120 sq. ft./qt.
(11.1 m
2
/l)
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity*
Touch
30 minutes
Handle
1 hour
Fully Dry
2-4 hours
Shelf Life
5 years
Dry Heat Resistance
200°F (93°C)
Flash Point
<105°F (41°C)
Safety Information
See SDS
Calculated values are shown and may vary slightly from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.