Technical Specifications

TECHNICAL DATA
SEMI-TRANSPARENT CONCRETE STAIN
Form: GDH-1345
Rev.: 050317
2
PRODUCT APPLICATION (cont.) .
SEALER APPLICATION
For maximum protection and durability, apply a film-
forming RockSolid Concrete Sealer (sold separately) over
the stained concrete surface. Allow the stain to dry for at
least 1 hour before topcoating. Follow the sealer label
instructions carefully. If desired, Rust-Oleum Anti-Skid
Additive can be sprinkled (by hand) into the wet surface.
RockSolid Concrete Sealer is not recommended for
use on garage floors. For additional protection on heavy
traffic areas or for more porous surfaces, apply a second
coat after 4-6 hours. Occasional touch-up or recoat may
be necessary for areas exposed to heavy foot or vehicle
traffic.
DRY TIMES
Dry times are based on 70ºF and 50% relative humidity.
Wait a minimum of 4 to 6 hours for light foot traffic. Wait
24 to 48 hours before returning heavy items, furniture and
vehicles.
PRODUCT APPLICATION (cont.) .
COVERAGE
Each gallon covers approximately 250-400 square feet on
smooth, bare concrete. Coverage on rough or porous
surfaces is approximately 175-250 square feet per gallon.
Coverage rates may vary depending on the desired stain
look.
CLEAN-UP
Wash tools and equipment with warm water and a mild
detergent immediately after use. Properly dispose of all
soiled rags and protect unused product from freezing.