Use and Care Manual

TECHNICAL DATA
SEMI-TRANSPARENT CONCRETE STAIN
Rust-Oleum Corporation Form: CS2310
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 102313
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
.PHYSICAL PROPERTIES .
CONCRETE STAIN
Resin Type
Acrylic Emulsion
Pigment Type
Inorganic Oxides
Solvents
Water
Weight
Per Gallon
8.50 – 8.63 lbs
Per Liter
1.02 – 1.03 kg
Solids
By Weight
11.3 – 13.8%
By Volume
9.6 – 10.7%
Volatile Organic Compounds
Max 100 g/l (0.83 lbs./gal.)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
250-400 sq.ft./gal. (6.2-9.8 m2/l) for bare smooth concrete
175-200 sq.ft./gal. (4.3-4.9 m2/l) for rough or porous surfaces
Dry Times at 70°
Fahrenheit (21°C)
and 50% Relative
Humidity
Touch
1 hour
Recoat
1 hour
Shelf Life
5 years
Flash Point
>200ºF (93ºC)
Safety Information
For additional information, see MSDS.
NOTE:
Calculated values may vary slightly from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.