How to Guide

TECHNICAL DATA
2300 SYSTEM INVERTED STRIPING PAINT
Rust-Oleum Corporation Form: GDH-1089
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 032216
Vernon Hills, Illinois 60061 www.rustoleum.com/industrial
An RPM Company
PHYSICAL PROPERTIES .
INVERTED STRIPING PAINT
Resin Type
Vinyl Toluene Modified Alkyd
Pigment Type
Varies with color
Solvents
Xylene and Toluene
Solids
By Weight
31-41%
By Volume
—
MIR
Maximum value of 1.2
Fill Weight
18 oz. (510 g)
Recommended Dry Film
Thickness (DFT) Per Coat
1.0-2.0 mils
(25-50µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
275-300 ft. @ 3" wide using 2348838 Yellow
Coverage is dependent on surface porosity
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Tack-free
<10 minutes
Handle
30 minutes
Recoat
Anytime
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Safety Information
THIS PRODUCT CONTAINS A CHEMICAL KNOWN TO THE STATE OF CALIFORNIA
TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.
DANGER! EXTREMELY FLAMMABLE. MAY CAUSE FLASH FIRE. CONTENTS
UNDER PRESSURE. VAPOR HARMFUL. FOR INDUSTRIAL OR COMMERCIAL USE
ONLY. SEE THE SAFETY DATA SHEET (SDS) AND LABEL WARNINGS FOR
ADDITIONAL SAFETY INFORMATION.
Calculated values are shown and may vary slightly from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.