Technical Specifications

TECHNICAL DATA
SPC-24
RUST-OLUEM
®
SPECIALTY
GLOW IN THE DARK
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙481∙4785
www.rustoleum.com
Form: GDH-917
Rev.: 021819
PHYSICAL PROPERTIES
GLOW IN THE DARK
Resin Type
Modified Acrylic Copolymer
Pigment Type
Modified Zinc Copper Chloride
Solvents
Propylene Glycol, Water
Weight
Per Gallon
9.34 lbs.
Per Liter
1.12 kg
Solids
By Weight
36.1%
By Volume
28.4%
Volatile Organic Compound
130 g/l (1.08 lbs./gal.)
Recommended Dry Film Thickness
(DFT) per Coat
1.5-2.5 mils
(37.5-62.5µ)
Wet Film to Achieve DFT
(unthinned material)
5.5-9.0 mils
(137.5-225µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
25 sq.ft/can
(0.6 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
45 minutes
Handle
4 hours
Recoat
45 minutes
Shelf Life
5 years
Flash Point
200°F (93°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.