Technical Specifications

TECHNICAL DATA SPC-25
SPECIA LTY
PAINT FOR PLASTIC
DESCRIPTION AND USES
Rust-Oleum
®
Paint for Plastic is designed to renew the
appearance of indoor and outdoor plastics. No primer is
required. These sprays are ideal for use on polypropylene,
polystyrene, resin, PVC, fiberglass, and vinyl plastics such
as chairs, tables, and planters. Some plastics made of
polyethylene such as Little T ikes
®
children’s products are
manufactured in a way that may hinder maximum paint
adhesion. Test this product in an inconspicuous area to test for
compatibility on the surface .
PRODUCT APPLICA TION
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50ºF (10ºC) and
90ºF (32ºC) and humidity is below 65% to ensure proper
drying. Avoid spraying in very windy and dusty conditions.
Cover surrounding area to protect from spray mist.
SURFACE PREP ARA TION
For new plastic surfaces, thoroughly wipe down surface with
paint thinner to promote adhesion. For aged or weathered
surfaces, remove loose material with a brush or scraper, c lean
with soap and water, rinse and let dry. Sanding may be required
for glossy or smooth surfaces. If mildew is present, wash with a
bleach solution, rinse and let dr y .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold can
APPLICATION (cont.)
upright 10-16” from surface and spray in a steady back-and-forth
motion, slightly overlapping each stroke. Keep the can the same
distance from the surface and in motion while spraying. A pply
2 or more light coats a few minutes apart. Maximum adhesion is
achieved in 5-7 days. Do not use near open flame.
DRY & RECOAT TIMES
Dry and recoat times are based on 70ºF and 50% rela tive
humidity. Allow more time at cooler temperatures. Dries to touch
in 20-30 minutes, to handle in 1 hour and fully dry in 24 hours.
Apply a second coat within 1 hour or after 48 hours.
CLEAN-UP
When finished spraying, clear spray valve by turning the can
upside down and pushing the nozzle for 5 seconds. Clean-up
wet paint with xylene or mineral spirits. Properly discard empty
container. Do not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a solvent
such as mineral spirits. Do not insert any object into can valve
opening.
1