Specification Sheet

TECHNICAL DATA
MARINE COATINGS – PRIMER FOR WOOD & FIBERGLASS
. PHYSICAL PROPERTIES .
Rust-Oleum Corporation Form: GDH-648
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 011217
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
SICAL t
PRIMER FOR WOOD & FIBERGLASS
Resin Type
Modified Alkyd
Pigment Type
Titanium Dioxide and Fillers
Solvents
Aromatic Hydrocarbons
Weight
Per Gallon
12.7 lbs.
Per Liter
1.52 kg
Solids
By Weight
70.0%
By Volume
46.0%
Volatile Organic Compounds
457 g/l (3.80 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
1.5-2.0 mils
(37.5-50µ)
Wet Film to Achieve DFT
(unthinned material)
3.0-6.0 mils
(75-150µ)
Practical Coverage at Recommended DFT
(assumes 15% material loss)
100 ft
2
/quart
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
1 hour
Handle
3 hours
Recoat
4 hours
Full Cure
72 hours
Dry Heat Resistance
250°F (121°C)
Shelf Life
3 years from manufacturing date
Flash Point
104°F (40°C)
Warning!
CAUTION! Combustible Liquid and Vapor
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.