How to Guide

TECHNICAL DATA SPC-13
SPECIALTY
METALLIC SPRAYS
Form: GDH-333
Rev.: 041416
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Specialty Metallic sprays provide a rich,
brilliant finish on wood, metal, and more. These sprays
add a shiny metallic look to picture frames, candle holders,
holiday crafts, and much more. This leafing metallic is
designed for use on interior decorative items only.
.PRODUCTS .
SKU Description
1910830 Gold
1915830 Silver
1936830 Brass
1937830 Copper
. PAINTING CONDITIONS .
Use outdoors or in a well ventilated area. Use when
temperature is between 50-90°F (10-32°C) and humidity is
below 85% to ensure proper drying. Do not apply to
surfaces, when heated, exceed 200°F (93°C). Do not
apply to galvanized steel. Avoid spraying in very windy
and dusty conditions. Cover surrounding area to protect
from spray mist.
. PRODUCT APPLICATION .
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical
contaminants by washing the surface with a commercial
detergent, or other suitable cleaning method. Rinse with
fresh water and allow to thoroughly dry. Remove loose
paint and rust with a wire brush or sandpaper. Previously
coated surfaces must be sound and in good condition.
Smooth, hard, or glossy finishes should be scarified by
sanding to create a surface profile.
WARNING! LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you sand, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
.PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Hold can upright 10-
16” from surface and spray in a steady back-and-forth
motion, slightly overlapping each stroke. Keep the can in
motion while spraying. Keep the can the same distance
from the surface. Apply two or more light coats a few
minutes apart to avoid drips and runs. Metallic sprays are
not recommended for outdoor use. Do not use near open
flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 15 minutes, to handle in 30 minutes
and is fully dry in 24 hours. Apply a second coat within 1
hour or after 24 hours. A clear coat finish is not
recommended.
CLEAN-UP
Clean valve immediately after use by turning can upside
down and depressing the spray button for 3-5 seconds
(some paint will be sprayed out, so be careful to not
inadvertently spray yourself or other objects). Clean up
wet paint with xylene or mineral spirits. Properly discard
empty container. Do not burn or place in home trash
compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.