Technical Specifications

TECHNICAL DATA
SPC-08
RUST-OLUEM
®
SPECIALTY
FROSTED GLASS
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙481∙4785
www.rustoleum.com
Form: GDH-329
Rev.: 021919
PHYSICAL PROPERTIES
FROSTED GLASS SPRAY
Resin Type
Acrylic Lacquer
Pigment Type
Proprietary
Solvents
Acetone, N-Butyl Acetate, Xylene
MIR
1.35 Max
Fill Weight
11 ounces
Practical Coverage
(assumes 15% material loss)
Approximately 7 sq.ft./can
(0.63 m
2
/can
Dry Times at 70-80ºF
(21-27ºC) and 50%
Relative Humidity
Touch
5 minutes
Fully Dry
10 minutes
Recoat
Anytime
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.