How to Guide

ALKYD TECHNICAL DATA IC-08
S1600 SYSTEM
INVERTED STRIPING PAINT
Rust-Oleum Corporation Form: GDH-26
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 071316
Vernon Hills, Illinois 60061 www.rustoleum.com/industrial
An RPM Company
.DESCRIPTION AND USES .
The S1600 System Inverted Aerosol Striping Paint is designed
specifically for creating crisp and clean, long-lasting lines. It is ideal for
use to mark aisles, lift truck routes, pallet positions, hazardous areas
and commercial parking lots.
These products are suitable for interior or exterior use on concrete,
grass, gravel or other types of pavement.
The S1600 System complies with USDA FSIS regulatory sanitation
performance standards for food establishment facilities.
.PRODUCTS .
SKU Description
1627838 Blue
1648838 Yellow
1665838 Red
1691838 White
263446 Dark Blue
1677838 Black
PACKAGING .
20 fl. oz. aerosol container (18 ounce fill weight)
6 aerosols per carton
.PRODUCT APPLICATION .
SURFACE PREPARATION
ALL SURFACES: Remove loose contaminants by sweeping
the surface before application of the coating. Grease, oil and
chemical contaminants are best removed by washing the
surface with Pure Strength
®
Cleaner/Degreaser item
#3599402, commercial detergent or other suitable cleaner.
Rinse thoroughly with fresh water and allow to fully dry.
APPLICATION
Use when temperature is above 32˚F (0˚C) and humidity is
below 85% to ensure proper drying. Protect surrounding
surfaces from overspray. Overspray can carry a significant
distance.
The Inverted Striping sprays are designed for use with the
Rust-Oleum Striping Machine item #2395000. Follow
machine directions for proper use. The width of the stripe
can be varied from 2 to 4 inches wide by adjusting the
position of the can holder on the Striping Machine. For best
results be sure the Striping Machine is in motion before
squeezing the trigger and release the trigger before stopping.
The inverted striping aerosols can also be used with the
#2388000 Striping Wand.
PHYSICAL PROPERTIES .
INVERTED STRIPING PAINT
Resin Type
Modified alkyd
Pigment Type
Varies with color
Solvents
Acetone, Xylene, and Toluene
MIR
Maximum value of 1.2
Fill Weight
18 oz.
Practical Coverage
Approximately 150 linear feet at 4" wide (46 meters at 10 cm.)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Tack-free
<10 minutes
Handle
30 minutes
Recoat
Anytime
Shelf Life
5 years
Safety Information
For additional information, see SDS
Calculated values are shown and may vary slightly from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature do
not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we can
guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All technical
information is subject to change without notice.