Manualshelf

Use and Care Manual

ManualsBrandsRust-Oleum Universal ManualsCraft Paint12 oz. All Surface Matte Metallic Capiz Spray Paint and Primer in One (Case of 6)
12
TECHNICAL DATA
UNI-25
UNIVERSAL
®
MATTE METALLIC SPRAYS
Form: ARJ-1907
Rev.:060822
DESCRIPTION AND USES
Universal
®
Matte Metallic Sprays are premium all-surface
paints that provides the ultimate long-lasting protection and
durability. This breakthrough, rust preventive formula adheres
to plastic, wood, metal, concrete, wicker, aluminum, and
masonry surfaces. A comfort grip trigger eliminates finger
fatigue caused by continuous spraying. Any angle spray
allows you to spray even upside down.
TIP:
Some plastics made of polyethylene such as plastic
storage containers are manufactured in a way that may hinder
maximum paint adhesion. Test paint in a hidden area first.
PRODUCTS
SKU
DESCRIPTION (Aerosol)
353093
Sunlit Brass
353092
Venetian Bronze
353091
Gunmetal Gray
365352
Copper
365358
Arctic Gray
371597
Capiz
PRODUCT APPLICATION
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants
by washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow
to thoroughly dry. Remove loose paint and rust with a wire
brush or sandpaper. Previously coated surfaces must be
sound and in good condition. Smooth, hard, or glossy
finishes should be scarified by sanding to create a surface
profile.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
APPLICATION
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90ºF
(10-32ºC) and humidity is below 65% to ensure proper
drying. Do not use on objects that may exceed 200ºF (93ºC)
surface temperature.
Do not apply to galvanized steel. Avoid spraying in very
windy and dusty conditions. Cover surrounding area to
protect from spray mist.
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Prior to
use, slide off the red safety clip from the trigger. Hold can
upright 8-12” from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the can
the same distance from the surface. Keep the can in motion
while spraying. Apply two or more light coats a few minutes
apart. For best results, apply several light coats versus one
heavy coat. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 30 minutes, to handle in 1 hour, and is fully dry in
24 hours. Recoat within 1 hour or after 48 hours.
CLEAN-UP
When finished spraying, wipe off tip before storing. Clean
up wet paint with xylene or mineral spirits. Properly discard
empty container. Do not burn or place in home trash
compactor.

Summary of content (2 pages)