Manualshelf

TDS

ManualsBrandsRust-Oleum Universal ManualsOther11 oz. All Surface Hammered Black Spray Paint and Primer in One
12
TECHNICAL DATA
UNI-01
UNIVERSAL
®
HAMMERED SPRAYS
1
DESCRIPTION AND USES
Universal
®
Hammered Sprays are versatile all-surface paints
that provide a durable protective coating with excellent
resistance to rust, and excellent resistance to abrasion,
fading, chipping, and dulling. Universal Hammered Sprays
are suitable for use on metal, wood, plastic, wicker and
aluminum. These sprays apply easily, provide excellent
coverage and dry fast to a tough attractive finish. Universal
features a comfort grip trigger that reduces fatigue caused by
continuous spraying and an any-angle tip which allows you to
spray at any angle.
TIP: Some plastics made of polyethylene such as plastic
storage containers are manufactured in a way that may hinder
maximum paint adhesion. Test paint in a hidden area first.
PRODUCTS
SKU
DESCRIPTION (Aerosol)
245217
Black
245218
Brown
245219
Silver
247567
Copper
258199
Dark Bronze
261416
Rosemary
267298
White
PRODUCT APPLICATION
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50-90ºF (10-
32ºC) and humidity is below 65% to ensure proper drying.
Do not use on objects that may exceed 200ºF (93ºC) surface
temperature.
Do not apply to galvanized steel. Avoid spraying in very
windy and dusty conditions. Cover surrounding area to
protect from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants
by washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow
to thoroughly dry. Remove loose paint and rust with a wire
brush or sandpaper. Previously coated surfaces must be
sound and in good condition. Smooth, hard, or glossy
finishes should be scarified by sanding to create a surface
profile.
PRODUCT APPLICATION (cont.)
SURFACE PREPARATION (cont.)
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and
a wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Prior to
use, slide off the red safety clip from the trigger. Hold can
upright 8-12” from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the can
the same distance from the surface. Keep the can in motion
while spraying. Apply two or more light coats a few minutes
apart. For best results, apply several light coats versus one
heavy coat. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 30 minutes, to handle in 1 hour, and is fully dry in
24 hours. Recoat within 1 hour or after 48 hours.
CLEAN-UP
When finished spraying, wipe off tip before storing. Clean
up wet paint with xylene or mineral spirits. Properly discard
empty container. Do not burn or place in home trash
compactor.

Summary of content (2 pages)