Manualshelf

Use and Care Manual

ManualsBrandsRust-Oleum Universal ManualsCraft Paint11 oz. All Surface Metallic Deep Navy Spray Paint (6-Pack)
12
TECHNICAL DATA
UNIVERSAL HAMMERED SPRAYS
Rust-Oleum Corporation Form: GDH-1061
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 022516
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
Dead Flat Clear
Hammered Clear
Frosted Pearl Clear
Resin Type
Proprietary Acrylic
Proprietary Acrylic
Proprietary Acrylic
Pigment Type
Polyethylene,
Polypropylene
Fumed Silica
Polyethylene
MIR
0.85 Max
0.85 Max
0.85 Max
Fill Weight
11 ounces
11 ounces
11 ounces
Solvents
Acetone, n-Butane, n-Butyl Acetate,
Propylene Glycol Monomethyl Ether
Acetate, Xylene, Glycol Ether PnB
Acetone, Ethyl Acetate, n-Butane, n-Butyl
Acetate, Xylene
Acetone, n-Butane, n-Butyl Acetate,
Propylene Glycol Monomethyl Ether
Acetate, Xylene, 3-Ethoxypropionate
Recommended Dry Film
Thickness (DFT) per Coat
1.0-2.0 mils
(25-50µ)
1.0-2.0 mils
(25-50µ)
0.5-1.0 mils
(12.5-25µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
6-8 sq.ft./can
(0.55-0.75 m
2
/can)
5-7 sq.ft./can
(0.5-0.65 m
2
/can)
6-10 sq.ft./can
(0.55-0.9 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
30 minutes
30 minutes
30 minutes
Handle
1 hour
1 hour
1 hour
Recoat
Anytime but wait 5
minutes between coats
Anytime but wait 5 minutes
between coats
Anytime but wait 5
minutes between coats
Dry Heat Resistance
200ºF (93ºC)
200ºF (93ºC)
200ºF (93ºC)
Shelf Life
5 years
5 years
5 years
Flash Point
-141ºF (-96ºC)
-141°F (-96°C)
-141°F (-96°C)
Safety Information
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this
literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our
control, we can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective
materials. All technical information is subject to change without notice.