MSDS

drying. Risk of overexposure depends on duration and level of exposure to dust from repeated sanding of surfaces
or spray mist and the actual concentration of Titanium Dioxide in the formula.
IARC lists Ethylbenzene as a possible human carcinogen (group 2B). May cause central nervous system disorder
(e,g.,narcosis involving a loss of coordination, weakness, fatigue, mental confusion, and blurred vision) and/or
damage. Reports have associated repeated and prolonged occupational overexposure to solvents with permanent
brain and nervous system damage. Contains carbon black. Chronic inflammation, lung fibrosis, and lung tumors
have been observed in some rats experimentally exposed for long periods of time to excessive concentrations of
carbon black and several insoluble fine dust particles. Tumors have not been observed in other animal species (i.e.,
mouse and hampster) under similar circumstances and study conditions. Epidemiological studies of North American
workers show no evidence of clinically significant adverse health effects due to occupational exposure to carbon
black.
Carbon black is listed as a Group 2B-"Possibly carcinogenic to humans" by IARC and is proposed to be listed as
A4- "not classified as a human carcinogen" by the American Conference of Govermental Industrial Hygienists.
Significant exposure is not anticipated during brush application or drying. Risk of overexposure depends on
duration and level of exposure to dust from repeated sanding of surfaces or spray mist and the actual concentration
of carbon black in the formula.
Primary Route(s) Of Entry: Skin Contact, Skin Absorption, Inhalation, Eye Contact
First Aid - Eye Contact: Hold eyelids apart and flush with plenty of water for at least 15 minutes. Get medical
attention.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: If you experience difficulty in breathing, leave the area to obtain fresh air. If continued
difficulty is experienced, get medical assistance immediately.
First Aid - Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material
can enter the lungs and cause severe lung damage. Get immediate medical attention.
Extinguishing Media: Dry Chemical, Foam, Water Fog
Unusual Fire And Explosion Hazards: FLASH POINT IS LESS THAN 20 °. F. -
EXTREMELY FLAMMABLE LIQUID
AND VAPOR! Water spray may be ineffective. Closed containers may explode when exposed to extreme heat.
Vapors may form explosive mixtures with air. Vapors can travel to a source of ignition and flash back. Perforation of
the pressurized container may cause bursting of the can. Keep containers tightly closed. Isolate from heat,
electrical equipment, sparks and open flame.
Special Firefighting Procedures: Evacuate area and fight fire from a safe distance.
Steps To Be Taken If Material Is Released Or Spilled: Remove all sources of ignition, ventilate area and remove
with inert absorbent and non-sparking tools. Contain spilled liquid with sand or earth. DO NOT use combustible
materials such as sawdust. Dispose of according to local, state (provincial) and federal regulations. Do not
incinerate closed containers.
Section 4 - First Aid Measures
Section 5 - Fire Fighting Measures
Flash Point:
-
156 F
LOWER EXPLOSIVE LIMIT: 0.7 %
(
Setaflash)
UPPER EXPLOSIVE LIMIT
:
36.0 %
Section 6 - Accidental Release Measures
Page
2
of
6
245196, 245197, 245198, 245210, 245211, 245212, 245213, 245214, 245215, 245216, 245
...