Use and Care Manual

TECHNICAL DATA
CAB-07
RUST-OLEUM
®
CABINET TRANSFORMATIONS
®
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 888∙577∙8459
www.rustoleum.com
Form: ARJ-2407
Rev.: 042222
PHYSICAL PROPERTIES
CABINET TRANSFORMATIONS
BOND COAT
TOP COAT
Resin Type
Water-Based Styrene Acrylic
Water-Based Acrylic
Pigment Type
Titanium dioxide, Inerts
NA
Solvents
Water, Propylene Glycol
Water, Glycol Ethers
Weight
Per Gallon
10.1-10.8 lbs.
8.3 lbs.
Per Liter
1.2-1.3 kg
1.0 kg
Solids
By Weight
47.3-51.8%
34.6%
By Volume
36.1-36.9%
34.9%
Volatile Organic Compounds
<50 g/l
<50 g/l
Recommended Dry Film Thickness
(DFT) Per Coat
1.5-3.0 mils
1.5-2.0 mils
Wet Film To Achieve DFT
(unthinned material)
4.0-8.0 mils
4.0-5.5 mils
Practical Coverage at Recommended
DFT (assumes 15% material loss)
50-100 sq. ft./kit
Coverage will vary depending on
surface texture & porosity
75-100 sq. ft./kit
Dry Times at 77°F
(25°C) and 50%
Relative Humidity
Touch
2 hours
2 hours
Recoat/Topcoat
2-4 hours
2-4 hours
Normal Use
24 hours
24 hours
Full Cure
7 Days
7 Days
Dry Heat Resistance
NA
NA
Flash Point
>200°F (93°C)
>200°F (93°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.