Use and Care Manual

TECHNICAL DATA

CAB-07

RUST-OLEUM

CABINET TRANSFORMATIONS

Form: ARJ-2407

Rev.: 042222

PRODUCT APPLICATION (cont.)

APPLICATION OF BOND COAT (cont.)

Continue to the FRONT SIDE of each door and drawer.

When the back side of each door is fully coated and dried

(approximately 2 hours), carefully turn the doors over.

Apply two coats of bond coat to each door and drawer front

using the same application process described in steps 1-3

on previous page. Be sure to coat the door and drawer

edges when completing the fronts, watching for drips.

APPLICATION OF THE TOPCOAT

The protective top coat is formulated to provide superior

stain and scratch resistance and is required for full

performance of the cabinet coating system.

Thoroughly stir the protective top coat. Using a 2” brush for

detailed areas and a ¼” nap roller for broad, open areas

apply an even layer of protective top coat to the cabinet

boxes and frames. As when you applied the bond coat -use

vertical strokes on the cabinet sides and stiles and horizontal

strokes on the rails. Once finished, inspect the surfaces and

touch up any light areas where more protective top coat is

needed.

Once the boxes and frames are complete, apply the

protective top coat to the BACK SIDE of the doors/drawers

first. Apply using the bond coat application method. Only

one coat of protective top coat is required. Allow 2 hours to

dry.

Coat the FRONT SIDE of the doors/drawers just as you

applied to the back sides. Avoid over brushing in previously

coated areas. If build-up occurs in recessed areas, wipe

them out using a clean, dry synthetic paint brush.

Allow the protective top coat to dry for 2 hours. Inspect the

surfaces and touch up any areas that need more protective

top coat. Allow final coated surfaces to dry for 12 hours

before re-installing your cabinet doors, drawers and

hardware. Install new door bumpers to back of doors and

drawers. The protective top coat will cure completely within 7

days –avoid cleaning until full 7 day cure.

COVERAGE

Up to 100 square feet per kit.

CLEAN UP

Soap and water.