Use and Care Manual

TECHNICAL DATA
WOOD FLOOR TRANSFORMATIONS KIT
Rust-Oleum Corporation Form: CS1767
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 112812
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
Clear Floor Finish
Resin Type
Polyurethane Dispersion
Pigment Type
NA
Solvents
Water
Weight-per Gallon
8.3-8.6 lbs
per Liter
1.0-1.03 kg
Solids by Weight
26.0-30.0%
Solids by Volume
26.0-30.0%
Volatile Ogranic Compounds
<275 g/l (2.3 lbs./gal.)
Recommended Dry Film
Thickness (DFT) per Coat
1.5-2.0 mils
Wet Film to Achieve DFT
(unthinned material)
5.0-7.5 mils
Theoretical Coverage at 1
mil DFT (25µ)
417-481 sq.ft./gal.
Practical Coverage at
Recommended DFT (assumes
15% material loss)
175-250 sq.ft./gal.
Dry Times
at 77°F
(25°C) and
50%
Relative
Humidity
Touch
1-2 hours
Handle
24 hours
Recoat
1-2 hours
Dry Heat Resistance
<212F (100°C)
Shelf Life
3 years
Flash Point
0°F (-18°C)
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.