Use and Care Manual

TECHNICAL DATA
WOOD FLOOR TRANSFORMATIONS KIT
2 Form: CS1767
Rev.: 112812
.PRODUCT APPLICATION (cont.) .
RINSE FLOOR
This rinse is to thoroughly remove any residual No Sanding
Refinishing Prep solution from the floor and prepares the surface for
the application of the final protective coat. In a clean bucket, mix ½ -1
ounce of liquid soap with each gallon of water. Pour the soap mixture
into a clean paint tray. Dampen a sponge mop by dipping it into the
paint tray. Apply the soap and water solution over one 4x4 foot
square section area at a time, rinsing the entire area. There is no
need to flood the floor. Wipe the surface dry with clean paper towels
or lint free rags. Repeat the process until entire floor has been rinsed.
Clean paint tray by rinsing it with warm water. DRY TIME: Allow floor
to dry to the touch (approximately 30 minutes) before applying the
Clear Floor Finish.
NOTE: Not recommended for use on floors badly damaged by water
stains, animal urine and gouges in the wood. These types of flooring
issues can result in delamination of the new floor finish.
APPLY THE POLYURETHANE CLEAR FLOOR FINISH
Apply only when air and surface temperatures are between 55-90°F
(13-32°C) and relative humidity is below 85%. Thoroughly stir Clear
Floor Finish slowly. DO NOT SHAKE. Be careful NOT to introduce
any bubbles into the mixture. Replace the scrub pad with the
synthetic applicator pad. Pour a portion of the Clear Floor Finish top
coat into a clean paint tray. Apply using a good quality, synthetic
brush or the application pad included with the kit. Apply the coating to
the floor in 4x4 foot sections, using smooth even strokes following the
direction of the wood grain. Pull the applicator pad towards you. Do
not push the pad away from you. Avoid pooling of coating.
Immediately after application, wash applicator pad with warm water.
Return remaining Clear Floor Finish to the container and cover tightly.
Allow the finish to dry for a minimum of 2 hours and then re-coat.
Lower temperatures and/or higher humidity may cause slower dry
times. Re-coat only when the previous coat has dried clear and feels
hard. If any coat has dried more than 24 hours, lightly sand before re-
coating. Apply a second coat following directions above. Allow the
finish to dry 8 hours before light use and 24 hours before returning to
normal use.
APPLICATION TIPS
Product appears milky when wet, but dries to a crystal clear coating.
Do not apply in direct sunlight. To prevent bubbles in the finish, do not
over-brush, shake or apply with a roller. Test the Floor Finish is an
inconspicuous area before beginning project.
CLEAN-UP
Use soap and water.