Use and Care Manual

TECHNICAL DATA
CABINET TRANSFORMATIONS
TM
Rust-Oleum Corporation Form: CS1796
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 043013
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
. PHYSICAL PROPERTIES .
DEGLOSSER
BOND COAT
TOP COAT
Resin Type
None
Acrylic / Urethane
Acrylic / Urethane
Pigment Type
None
Titanium dioxide, mica, inerts
Titanium dioxide, mica, inerts
Solvents
Water
Water
Water
Weight
Per Gallon
8.40 lbs.
9.80-11.90 lbs.
8.47 lbs.
Per Liter
Solids
By Weight
4.8%
40-58%
29%
By Volume
4.5%
30-42%
27%
Volatile Organic Compounds
<465 g/l
(3.85 lbs./gal.)
<85 g/l
(0.70 lbs./gal.)
<272 g/l
(2.3 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
NA
2.0-2.5 mils
(50-62.5µ)
4.0-8.0 mils
(100-200µ)
Wet Film to Achieve DFT
(unthinned material)
6.6-7.5 mils
(165-187.5µ)
14.8-30.0 mils
(370-750µ)
Practical Coverage at
Recommended DFT (assumes 15%
material loss)
160-200 sq. ft./gal.
(3.9-4.7 m
2
/l)
46-92 sq. ft./gal.
(1.1-2.3 m
2
/l)
Dry Times at
77°F (25°C)
and 50%
Relative
Humidity
Working Time
30 minutes
30 minutes
30 minutes
Dry to Recoat
1 hour
2-3 hours
n/a
Full Cure
n/a
n/a
24 hours
Dry Heat Resistance
n/a
200°F (93°C)
200°F (93°C)
Shelf Life
n/a
3 years
3 years
Storage
Safety
Information
Flash Point
220°F (105°C)
215°F (102°C)
215°F (102°C)
Warning!
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.