Instructions / Assembly

APPLICATION TIPS
Q. WHAT SHOULD I DO IF THE SCREEN OF MY DIAMOND EMBEDDED
SANDING TOOL GETS CLOGGED WITH CHIP DUST?
A. Simply clean out the dust using a shop vacuum with a hose attachment.
TIP: Do not apply Adhesive Base Coat onto too large an area at one time.
Once Adhesive Base Coat starts to dry, Decorative Chips will not adhere well.
Disperse Chips as quickly as possible while Adhesive Base Coat is still wet. To
disperse Chips by hand, quickly scoop and spread/sprinkle. When done, go
over the countertop with a flashlight, looking for glossy areas with low
Decorative Chip density and spread additional Chips as needed.
Flaws in Top Coat Finish: You MUST use a lint-free, high density foam roller
such as the Whizz
®
6” Doors and Cabinet foam roller. Make sure to apply
enough Protective Top Coat to cover Chips completely. This can be easily
done by applying a first coat, then back-rolling in one direction over the first
wet coat. Do not turn on a fan directly onto countertop to try and dry top coat
faster.
Q. WHAT CAN I DO TO KEEP THE ADHESIVE BASE COAT WET LONGER?
A. To keep the Adhesive Base Coat wet prior to applying the Decorative Chips,
keep windows closed and ceiling fans off. Avoid air movement or breezes
while applying Adhesive Base Coat. This may cause it to dry faster. The
Wetting Agent allows the surface to stay wet longer allowing the chips to
better adhere to the Adhesive Base Coat.
(continued)