Instructions / Assembly

STEP #5 APPLY PROTECTIVE TOP COAT
(Time: approximately 1 hour for 50 square feet of countertops)
In this final step, the Protective Top Coat will create a beautiful, lasting
and protective finish for your new countertop surfaces. The Protective
Top Coat is low-odor and requires no special ventilation.
E. Use a vacuum with brush attachment or a soft hand brush to remove chip
dust. Rub your bare hand over the countertop surface to check for any
rough or raised areas. Gently re-sand missed rough/uneven areas and then
remove dust using the vacuum or hand brush. Remember - keep a light
touch on corners and edges - you only need enough pressure to create a
smooth, lightly textured surface.
F. Wipe the surface clean with a damp, lint-free cloth and allow to dry.
G. Rub your bare hand over the countertop to check for leftover dust. If you
see dust on your hand, continue to wipe the countertop again with a damp
lint free cloth and let dry. Repeat as necessary until all sanding dust has
been removed.
H. Once the dust is gone, wipe down once more with a damp lint free cloth
for the final cleaning.
I. Clean up all spilled or dropped chips and dust.
IMPORTANT: Contents of Protective Top Coat are combustible until applied
to the surface. Extinguish all flames and pilot lights, and turn off stoves,
heaters, electric motors and other sources of ignition during use until project
is complete. Keep away from heat, sparks and flame. Do not smoke.
HOUR
1 HOUR
IMPORTANT: After sanding, if you notice any over-sanded or bare areas, you
can easily do touch-ups using the “Touch-Up Instructions” in the FAQ section.