Instructions / Assembly

COUNTERTOP PREPARATION AND REPAIR

Q. PRIOR TO USING COUNTERTOP TRANSFORMATIONS™, HOW DO I

REPAIR CRACKS, CUTS, CHIPS, SCRATCHES OR BURNS IN MY ORIGINAL

COUNTERTOP?

A. Countertop Transformations™ will coat and cover any burns and small

scratches in the existing countertop. Cracks, chips, deeper cuts or dents can

be repaired by ﬁlling them with a 2-part epoxy putty. When the putty dries,

sand the area until it is even with the surrounding surface. Once repairs

have been made, follow the normal application process.

Q. WHAT IF MY ORIGINAL COUNTERTOP LAMINATE IS DELAMINATING?

A. The original countertop needs to be in good structural condition before

reﬁnishing. If there is delamination, properly reattach the laminate. If

existing laminate is blistering, bubbling or buckling, do NOT use the

Countertop Transformations™.

Q. WHAT IF I MAKE A MISTAKE DURING THE COUNTERTOP REFINISHING

PROCESS?

A. Poor chip adhesion or chips removed by leaning on or touching the surface:

Easy ﬁx! Just use a damp sponge dipped into the Adhesive Base Coat and

lightly sponge on the area and immediately cover the area with Decorative

Chips. For small repairs, you can apply chips by hand. Simply throw chips by

the handful with force to the wet repaired area.

Over-sanded or bare areas: Just dip a damp sponge into the

Adhesive Base Coat, sponge it onto the surface and immediately cover with

Chips. After 4 hours, sand down the area until it is even with the

surrounding area. Continue with Protective Top Coat application.