Instructions / Assembly

STEP #4 SAND AND SMOOTH

(Time: approximately 2 hours for 50 square feet of countertops)

At this point, the rough-to-the-touch Decorative Chip surface will be

scraped and sanded to a beautiful, smooth ﬁnish using the Chip

Scraper and the Diamond Embedded Sanding Tool.

Use a hand brush or vacuum to gently remove loose, excess Decorative

Chips from the surface.

2 HOUR

C. Once the entire countertop has been fully covered with Decorative Chips,

visually inspect the counter, front edge and backsplash to make sure that

100% of the Adhesive Base Coat has been completely covered with

Decorative Chips. It is important that NO GLOSSY ADHESIVE can be seen

through the Decorative Chips. Apply more Decorative Chips as needed to

lightly covered areas.

D. Once the countertop is completely covered with Decorative Chips, DO

NOT TOUCH the new surface.

Allow the new coating to dry overnight for a minimum of 12 hours.

However, you must sand within 24 hours of applying the Adhesive Base Coat.

IMPORTANT:

Be careful not to lean into the front edge of the countertop

while applying Decorative Chips. If you happen to bump into wet Adhesive

Base Coat before the chips are applied, just sponge on more Adhesive Base

Coat, re-coat with Decorative Chips, and keep moving.

Tools needed: Chip Scraper, Diamond Embedded Sanding Tool,

Sanding Block, Dust Mask, and Vacuum or Hand Brush