MSDS

Primary Route(s) Of Entry: Skin Contact, Skin Absorption, Inhalation, Ingestion, Eye Contact
First Aid - Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open.
Get medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give
oxygen. Get immediate medical attention. Do NOT use mouth-to-mouth resuscitation.
First Aid - Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material
can enter the lungs and cause severe lung damage. Get immediate medical attention.
Extinguishing Media: Film Forming Foam, Carbon Dioxide, Dry Chemical, Water Fog
Unusual Fire And Explosion Hazards: Keep containers tightly closed.
Special Firefighting Procedures: Evacuate area and fight fire from a safe distance. Water may be used to cool
closed containers to prevent pressure buildup and possible autoignition or explosion.
Steps To Be Taken If Material Is Released Or Spilled: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Dispose of according to local, state (provincial) and federal regulations.
Do not incinerate closed containers.
Handling: Wash thoroughly after handling. Follow all MSDS/label precautions even after container is emptied
because it may retain product residues. Avoid breathing vapor or mist. Avoid contact with eyes. Wash hands
before eating.
Storage: Keep away from heat, sparks, flame and sources of ignition. Keep container closed when not in use.
Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame.
Engineering Controls: Prevent build-up of vapors by opening all doors and windows to achieve cross-ventilation.
Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below
recommended exposure limits.
Respiratory Protection: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2
requirements must be followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA
Section 4 - First Aid Measures
Section 5 - Fire Fighting Measures
Flash Point: 104 F LOWER EXPLOSIVE LIMIT: 0.7 %
(
Setaflash)
UPPER EXPLOSIVE LIMIT
:
8.9 %
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Section 8 - Exposure Controls / Personal Protection
Page
2
of
5
7791502 STRUST QT 2PK SATIN WHITE