MSDS

Contains crystalline silica as silicon dioxide. Excessive inhalation of respirable crystalline silica dust may cause
lung disease, silicosis or lung cancer. Significant exposure is not anticipated during brush or trowel application or
drying. Risk of overexposure depends on the duration and level of exposure to dust from repeated sanding of
surfaces, mechanical abrasion or spray mist and actual concentration of crystalline silica in the formula.
Crystalline silica is listed as Group 1 "carcinogenic to humans" by the International Agency for Research on
Cancer (IARC), and Group 2 "reasonably anticipated to be a carcinogen" by the National Toxicology Program
(NTP).
Primary Route(s) Of Entry: Skin Contact, Skin Absorption, Inhalation, Ingestion, Eye Contact
First Aid - Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open.
Get medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give
oxygen. Get immediate medical attention. Do NOT use mouth-to-mouth resuscitation.
First Aid - Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material
can enter the lungs and cause severe lung damage. Get immediate medical attention.
Flash Point: 81 F (Setaflash)
Extinguishing Media: Film Forming Foam, Carbon Dioxide, Dry Chemical, Water Fog
Unusual Fire And Explosion Hazards: Vapors may form explosive mixtures with air. Vapors can travel to a source
of ignition and flash back. Isolate from heat, electrical equipment, sparks and open flame.
Special Firefighting Procedures: Water may be used to cool closed containers to prevent pressure buildup and
possible autoignition or explosion. Evacuate area and fight fire from a safe distance.
Steps To Be Taken If Material Is Released Or Spilled: Eliminate all ignition sources; use explosion-proof
equipment. Place material in a container and dispose of according to local, provincial, state and federal
regulations. Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust.
Handling: Wash thoroughly after handling. Follow all MSDS/label precautions even after container is emptied
because it may retain product residues. Use with adequate ventilation. Wash hands before eating.
Storage: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Keep
away from heat, sparks, flame and sources of ignition. Keep container closed when not in use.
Section 4 - First Aid Measures
Section 5 - Fire Fighting Measures
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Section 8 - Exposure Controls / Personal Protection
Page
2
of
5
7769502 STRUST QT 2PK FLAT RUSTY METAL PRIMER
12/6/2010
file://O:\Program%20Files\ProductVision%204.0\REPORTS\~PV66278.htm