MSDS

Steps To Be Taken If Material Is Released Or Spilled: Dispose of according to local, state (provincial) and federal
regulations. Do not incinerate closed containers. Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Remove all sources of ignition, ventilate area and remove with inert
absorbent and non-sparking tools.
Handling: Wash thoroughly after handling. Wash hands before eating. Use only in a well-ventilated area. Follow
all MSDS/label precautions even after container is emptied because it may retain product residues. Avoid
breathing vapor or mist.
Storage: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Contents
under pressure. Do not expose to heat or store above 120 ° F. Do not store above 120 ° F. Store large quantities
in buildings designed and protected for storage of NFPA Class I flammable liquids.
Engineering Controls: Use process enclosures, local exhaust ventilation, or other engineering controls to control
airborne levels below recommended exposure limits. Use explosion-proof ventilation equipment. Prevent build-up
of vapors by opening all doors and windows to achieve cross-ventilation.
Respiratory Protection: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2
requirements must be followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA
approved air purifying respirator with an organic vapor cartridge or canister may be permissible under certain
circumstances where airborne concentrations are expected to exceed exposure limits.
Protection provided by air purifying respirators is limited. Use a positive pressure air supplied respirator if there is
any potential for an uncontrolled release, exposure levels are not known, or in any other circumstances where air
purifying respirators may not provide adequate protection.
Skin Protection: Nitrile or Neoprene gloves may afford adequate skin protection. Use impervious gloves to prevent
skin contact and absorption of this material through the skin.
Eye Protection: Use safety eyewear designed to protect against splash of liquids.
Other protective equipment: Refer to safety supervisor or industrial hygienist for further information regarding
personal protective equipment and its application.
Hygienic Practices: Wash thoroughly with soap and water before eating, drinking or smoking.
(See section 16 for abbreviation legend)
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Section 8 - Exposure Controls / Personal Protection
Section 9 - Physical And Chemical Properties
Vapor Density:
Heavier than Air Odor: Solvent Like
Appearance:
Liquid
Evaporation Rate:
Faster than Ether
Solubility in H2O:
Slight
Freeze Point:
N.D.
Specific Gravity:
0.796
pH:
N.D.
Physical State:
Liquid
Page
3
of
6
7222830 STRUST +SSPR 6PK TEXTUR FOREST GREEN