MSDS

ManualsBrandsRust-Oleum Stops Rust ManualsPaint1-qt. Gray Hammered Rust Preventive Paint (2-Pack)

Date Printed: 2/1/2013

Xylene 1330-20-7 5.0 100 ppm 150 ppm 100 ppm N.E.

1,2,4-Trimethylbenzene 95-63-6 5.0 25 ppm N.E. N.E. N.E.

1,3,5-Trimethylbenzene 108-67-8 5.0 25 ppm N.E. N.E. N.E.

Aluminum Flake 7429-90-5 5.0 1 mg/m3 N.E.

15 mg/m3 [Total

Dust]

N.E.

Ethylbenzene 100-41-4 5.0 20 ppm 125 ppm 100 ppm N.E.

Carbon Black 1333-86-4 1.0 3 mg/m3 N.E. 3.5 mg/m3 N.E.

4. First-aid Measures4. First-aid Measures

FIRST AID FIRST AID

EYE CONTACT: EYE CONTACT:

Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open. Get medical

attention. Do NOT allow rubbing of eyes or keeping eyes closed.

FIRST AID FIRST AID

SKIN CONTACT: SKIN CONTACT:

Wash skin with soap and water. Remove contaminated clothing. Get medical attention if irritation

develops or persists.

FIRST AID FIRST AID

INHALATION: INHALATION:

Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get

immediate medical attention. Do NOT use mouth-to-mouth resuscitation.

FIRST AID FIRST AID

INGESTION: INGESTION:

Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the

lungs and cause severe lung damage. Get immediate medical attention.

5. Fire-fighting Measures5. Fire-fighting Measures

Flash Point, °F 53 (Setaflash)

EXTINGUISHING MEDIA: Alcohol Foam, Carbon Dioxide, Dry Chemical, Foam, Water Fog

UNUSUAL FIRE AND EXPLOSION HAZARDS: Vapors may form explosive mixtures with air. Vapors can travel to a source of

ignition and flash back. Isolate from heat, electrical equipment, sparks and open flame.

SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent pressure buildup and possible

autoignition or explosion. Evacuate area and fight fire from a safe distance.

6. Accidental Release Measures

STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use

combustible materials such as sawdust. Eliminate all ignition sources; use explosion-proof equipment. Place material in a container

and dispose of according to local, provincial, state and federal regulations.

7. Handling and Storage

HANDLING: Wash thoroughly after handling. Wash hands before eating. Use only with adequate ventilation. Follow all

MSDS/label precautions even after container is emptied because it may retain product residues.

STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Keep away from heat,

sparks, flame and sources of ignition. Keep container closed when not in use.

8. Exposure Controls/Personal Protection

ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne

levels below recommended exposure limits. Prevent build-up of vapors by opening all doors and windows to achieve cross-

ventilation.

Page 2 / 5