SDS

Date Printed: 10/23/2023
Cumene 98-82-8 0.1-1.0
GHS02-GHS07-
GHS08
H226-302+H332-304-335-350
Zirconium Acetate 5153-24-2 <0.1 Not Available Not Available
4. First-Aid Measures
FIRST AID - EYE CONTACT: Remove contact lenses, if present and easy to do. Continue rinsing. Immediately flush eyes with
plenty of water for at least 15 minutes holding eyelids open. Get medical attention. Do NOT allow rubbing of eyes or keeping eyes
closed.
FIRST AID - SKIN CONTACT: Wash contaminated clothing and decontaminate footwear before reuse. Immediately flush skin with
plenty of water for at least 15 minutes while removing clothing. Get medical attention immediately. Wash clothing separately before
reuse.
FIRST AID - INHALATION: No Information
FIRST AID - INGESTION: Do not induce vomiting unless advised by a physician. Call nearest Poison Control Center or Physician
immediately.
5. Fire-Fighting Measures
EXTINGUISHING MEDIA: Aqueous Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog
UNUSUAL FIRE AND EXPLOSION HAZARDS: Closed containers may explode when exposed to extreme heat. Vapors can travel
to a source of ignition and flash back. Keep containers tightly closed. DO NOT apply to hot surfaces. Isolate from heat, electrical
equipment, sparks and open flame.
SPECIAL FIREFIGHTING PROCEDURES: Water may be used to cool closed containers to prevent pressure buildup and possible
autoignition or explosion. Water may be used to cool closed containers to prevent buildup of steam. Evacuate area and fight fire
from a safe distance. Containers can rupture and release highly toxic material if exposed to heat. Use water spray to keep fire-
exposed containers cool. Containers may explode when heated.
Special Fire and Explosion Hazard (Combustible Dust): Not a combustible dust.
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Local authorities should be advised if significant spillages
cannot be contained. Avoid runoff into sewers and waterways. Provide ventilation and approach spill from upwind using proper
personal protective equipment as indicated in Section 8. Evacuate the area, remove all sources of ignition and ventilate well.
Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust. Eliminate all ignition sources; use
explosion-proof equipment. Place material in a container and dispose of according to local, provincial, state and federal regulations.
Remove all sources of ignition, ventilate area and remove with inert absorbent and non-sparking tools.
7. Handling and Storage
HANDLING: Wash thoroughly after handling. Wash hands before eating. Remove contaminated clothing and launder before reuse.
Use only with adequate ventilation. Ground and bond containers when transferring material from one vessel to another. Vapor can be
ignited by static discharge. Use spark-proof tools and explosion-proof equipment. Avoid prolonged or repeated contact with skin. Do
not get in eyes, on skin or clothing.
STORAGE: Store in a dry, well ventilated place. Keep container tightly closed when not in use. Keep containers tightly closed.
Isolate from heat, electrical equipment, sparks and open flame. Keep away from heat, sparks, flame and sources of ignition. Avoid
excess heat.
Advice on Safe Handling of Combustible Dust: No Information
8. Exposure Controls / Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-TWA
OSHA PEL-
CEILING
Naphtha, Petroleum,
Hydrotreated Light
64742-49-0 25.0 N.E. N.E. N.E. N.E.
Solvent Naphtha, Light Aromatic 64742-95-6 10.0 N.E. N.E. N.E. N.E.
Xylenes (o-, m-, p- Isomers) 1330-20-7 10.0 20 ppm N.E. 100 ppm N.E.
1,2,4-Trimethylbenzene 95-63-6 5.0 10 ppm N.E. N.E. N.E.
Stops Rust / Hammered Brush-On Paint
Page 3 / 7