MSDS

Primary Route(s) Of Entry: Skin Contact, Skin Absorption, Inhalation, Ingestion, Eye Contact
First Aid - Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes holding eyelids open.
Get medical attention. Do NOT allow rubbing of eyes or keeping eyes closed.
First Aid - Skin Contact: Wash with soap and water. Get medical attention if irritation develops or persists.
First Aid - Inhalation: Remove to fresh air. If not breathing, give artificial respiration. If breathing is difficult, give
oxygen. Get immediate medical attention. Do NOT use mouth-to-mouth resuscitation.
First Aid - Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material
can enter the lungs and cause severe lung damage. Get immediate medical attention.
Flash Point: 52 F (Setaflash)
Extinguishing Media: Film Forming Foam, Carbon Dioxide, Dry Chemical, Dry Sand, Water Fog
Unusual Fire And Explosion Hazards: Isolate from heat, electrical equipment, sparks and open flame. Vapors may
form explosive mixtures with air. Vapors can travel to a source of ignition and flash back.
Special Firefighting Procedures: Evacuate area and fight fire from a safe distance. Water may be used to cool
closed containers to prevent pressure buildup and possible autoignition or explosion.
Steps To Be Taken If Material Is Released Or Spilled: Eliminate all ignition sources; use explosion-proof
equipment. Place material in a container and dispose of according to local, provincial, state and federal
regulations. Contain spilled liquid with sand or earth. DO NOT use combustible materials such as sawdust.
Handling: Use with adequate ventilation. Wash thoroughly after handling. Wash hands before eating. Follow all
MSDS/label precautions even after container is emptied because it may retain product residues.
Storage: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Keep
away from heat, sparks, flame and sources of ignition. Keep container closed when not in use.
Engineering Controls: Prevent build-up of vapors by opening all doors and windows to achieve cross-ventilation.
Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne levels below
recommended exposure limits.
Respiratory Protection: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2
requirements must be followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA
approved air purifying respirator with an organic vapor cartridge or canister may be permissible under certain
circumstances where airborne concentrations are expected to exceed exposure limits.
Section 4 - First Aid Measures
Section 5 - Fire Fighting Measures
Section 6 - Accidental Release Measures
Section 7 - Handling And Storage
Section 8 - Exposure Controls / Personal Protection
Page
2
of
5
7210502 STRUST QT 2PK HAMMER GOLD