Use and Care Manual

TECHNICAL DATA
SRT-58
STOPS RUST
®
CUSTOM SPRAY 5-IN-1 ENAMELS
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙481∙4785
www.rustoleum.com
Form: ARJ-2528
Rev.: 110122
PHYSICAL PROPERTIES
STOPS RUST CUSTOM 5-IN-1 SPRAYS
Resin Type
Oil modified Alkyd
Pigment Type
Varies depending on color
Solvents
Acetone, N-Butyl Acetate, Aromatic Hydrocarbons
MIR
Flat - 0.80 max
Gloss, Satin and Semi-Gloss - 0.95 max
Fill Weight
12 oz.
Recommended Dry Film
Thickness (DFT) per Coat
1.0-2.0 mils
Practical Coverage at Recommended
DFT (assume 15% material loss)
6-10 sq. ft./. can
Dry Times at 70-80°F
(21-27ºC) and 50%
Relative Humidity
Touch
2-4 hours
Handle
5-9 hours
Recoat
Before 1 hour and after 48 hours
Shelf Life
5 years
Flash Point
-141°F (-96°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.