Use and Care Manual

TECHNICAL DATA
SRT-58
STOPS RUST
®
CUSTOM SPRAY 5-IN-1 ENAMELS
2
Form: ARJ-2528
Rev.: 110122
PRODUCT APPLICATION (cont.)
APPLICATION
Use outdoors or in a well-ventilated area such as an open
garage. Use when temperature is between 50-90°F
(10-32°C) and humidity is below 65% to ensure proper
drying. Do not apply to surfaces that, when heated, exceed
200°F (93°C) or galvanized metal. Avoid spraying in very
windy, dusty conditions. Cover surrounding area to protect
from spray mist.
Before spraying, turn dial to the desired spray pattern and
test on an inconspicuous area or on scrap material. Scan
QR code to learn more. Shake can vigorously for one minute
after mixing ball begins to rattle. If mixing ball fails to rattle,
DO NOT STRIKE CAN. Contact Rust-Oleum. Shake often
during use. Keep the can the same distance from the
surface. Recommended distance from the surface will vary
based on spray selection. Scan QR code on can for details.
Keep the can in motion while spraying. Spray in a steady
back-and-forth motion, slightly overlapping each stroke.
Spray at any angle. Apply 2 or more light coats a few
minutes apart. Turn dial to LOCK position when finished
spraying.
Dial Position
Spray Description
Recommend Spray
Distance
1
High Output
10-14”
2
Standard
8-12”
3
Low Output
3-6”
4
Vertical Fan
8-12”
5
Horizontal Fan
8-12”
PRODUCT APPLICATION (cont.)
DRY AND RECOAT TIMES
Based on 70°F (21°C)-50% relative humidity. Allow more
time at cooler temperatures. Dries to touch in 2-4 hours, to
handle in 5-9 hours, and is fully dry in 24 hours. Apply a
second coat or Clear coat within 1 hour or after 48 hours.
Apply Clear in 2-3 light coats a few minutes apart. Primers
may be top coated immediately.
DIAL CARE AND CLOGGING
To prevent clogging, clean face of the dial with mineral
spirits when finished spraying. DO NOT remove cap or dial.
CLEAN UP
To remove wet paint, clean with mineral spirits. Throw away
empty can in trash pickup. Do not burn or place in home
trash compactor.