Use and Care Manual

TECHNICAL DATA
SRT-08
STOPS RUST
®
BRIGHT COAT
METALLIC SPRAYS
Rust-Oleum Corporation
11 Hawthorn Parkway
Vernon Hills, Illinois 60061
Phone: 800∙481∙4785
www.rustoleum.com
Form: GDH-709
Rev.: 092118
PHYSICAL PROPERTIES
BRIGHT COAT METALLIC SPRAYS
Resin Type
Solvent Acrylic
Pigment Type
Varies with color
MIR
1.25 Max
Fill Weight
11 ounces
Solvents
Acetone, Toluene, Xylene
Recommended Dry Film Thickness
(DFT) Per Coat
1.0-2.0 mils
(25-50µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
4-6 sq.ft./can
(0.37-0.56 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
1 hour
Handle
1 hour
Recoat
Before 1 hour or after 48 hours
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
156°F (69°C)
Safety Information
For additional information, see SDS
Calculated values are shown and may vary from the actual manufactured material.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The
statements of this literature do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use
of our materials are beyond our control, we can guarantee these products only to conform to our standards of quality, and our liability, if any,
will be limited to replacement of defective materials. All technical information is subject to change without notice.