Manualshelf

Use and Care Manual

ManualsBrandsRust-Oleum Stops Rust ManualsGeneral Purpose Spray Paint11 oz. Bright Coat Rose Gold Spray Paint (6-Pack)
12
TECHNICAL DATA
SRT-08
STOPS RUST
®
BRIGHT COAT
METALLIC SPRAYS
1
DESCRIPTION AND USES
Rust-Oleum
®
Stops Rust
®
Bright Coat Metallic Sprays are
designed to provide a durable protective coating with
excellent resistance to rust, and excellent resistance to
abrasion, fading, chipping, and dulling. These sprays apply
easily, provide excellent coverage and dry fast to a tough
attractive finish. Aluminum is appropriate for outdoor metal
surfaces when primed first. Gold, Chrome, and Bronze
should be used indoors as they will tarnish if placed
outdoors. These sprays feature a comfort tip with a wider
finger pad to reduce fatigue caused by continuous spraying
and the any-angle tip which allows you to spray at any angle.
PRODUCTS
SKU
DESCRIPTION (Aerosol)
7710830
Gold
7713830
Dark Bronze
7715830
Aluminum
7718830
Gloss Chrome
V7715830
VOC Aluminum
313820
Copper
PRODUCT APPLICATION
Use outdoors or in a well-ventilated area such as an open
garage. Use when temperature is between 50°-90°F (10°-
32°C) and humidity is below 70% to ensure proper drying. Do
not apply to surfaces that, when heated, exceed 200°F (93°C)
or galvanized metal. Avoid spraying in very windy, dusty
conditions. Cover surrounding area to protect from spray
mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, salt and chemical contaminants
by washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow to
thoroughly dry. Remove loose paint and rust with a wire
brush or sandpaper. Previously coated surfaces must be
sound and in good condition. Smooth, hard, or glossy
finishes should be scarified by sanding to create a surface
profile.
WARNING! If you scrape, sand or remove old paint from any
surface, you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH approved respirator to control
lead exposure. Clean up carefully with a HEPA vacuum and a
wet mop. Before you start, find out how to protect yourself
and your family by contacting the National Lead Information
Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
PRIMING
Use of a Stops Rust
®
Primer provides added corrosion
protection, superior adhesion and hiding and is especially
recommended for bare wood and metal. The following
primers are recommended.
7769
Rusty Metal Primer
7780
Clean Metal Primer
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. Shake often during use. Hold can
upright 10-16" from surface and spray in a steady back-and-
forth motion, slightly overlapping each stroke. Keep the can
the same distance from the surface. Keep the can in motion
while spraying. Apply two or more light coats a few minutes
apart to avoid drips and runs. Do not use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 1 hour and primers may be top coated immediately.
Apply a second coat within 1 hour or after 48 hours. A clear
coat finish is not recommended.
CLEAN-UP
Wipe off tip before storing. Clean-up wet paint with xylene or
mineral spirits. Properly discard empty container. Do not burn
or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object into
can valve opening.

Summary of content (2 pages)