Use and Care Manual

TECHNICAL DATA
STOPS RUST ENAMEL SPRAYS
2 Form: GDH-678
Rev.: 121615
..PRODUCT APPLICATION (cont.
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 10-16" from the surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can the same distance from the surface.
Keep the can in motion while spraying. Apply 2 or more
light coats a few minutes apart to avoid runs and sags.
Metallic Sprays are not recommended for outdoor use. Do
not use near open flame.
DRY AND RECOAT
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries
tack-free in 2-4 hours, to handle in 5-9 hours, and is fully
dry in 24 hours. Apply a second coat within 1 hour or after
48 hours.
..PRODUCT APPLICATION (cont.
CLEAN UP
Wipe off tip before storing. Clean-up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.