Use and Care Manual

TECHNICAL DATA
STOPS RUST ENAMEL SPRAYS
Rust-Oleum Corporation Form: CS2201
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 090313
Vernon Hills, Illinois 60061 www.rustoleum.com
PHYSICAL PROPERTIES .
ENAMEL SPRAY FINISHES
Resin Type
Oil modified alkyd
Pigment Type
Varies with color
MIR
Xylene, Aliphatic Hydrocarbons
Fill Weight
1.4 Max
Solvents
12 ounces
Recommended Dry Film Thickness
(DFT) Per Coat
1.0-2.0 mils (25-50µ)
Practical Coverage at Recommended
DFT (assumes 15% material loss)
10-12 sq.ft./can
(0.9-1.09 m
2
/can)
Dry Times at
70°F (21°C) and
50% Relative
Humidity
Tack-free
2-4 hours
Handle
5-9 hours
Recoat
Before 1 hour or after 48 hours
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.