MSDS

Date Printed: 11/14/2014
8. Exposure Controls/Personal Protection
ENGINEERING CONTROLS: Use explosion-proof ventilation equipment. Provide general dilution of local exhaust ventilation in
volume and pattern to keep TLV of hazardous ingredients below acceptable limits. Prevent build-up of vapors by opening all doors
and windows to achieve cross-ventilation. Use process enclosures, local exhaust ventilation, or other engineering controls to control
airborne levels below recommended exposure limits.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must be
followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with organic
vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to exceed
exposure limits.
SKIN PROTECTION: Use gloves to prevent prolonged skin contact. Nitrile or Neoprene gloves may afford adequate skin protection.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
HYGIENIC PRACTICES: Wash thoroughly with soap and water before eating, drinking or smoking. Remove contaminated clothing
immediately and launder before reuse.
9. Physical and Chemical Properties
Vapor Density Heavier than Air Odor: Solvent Like
Appearance: Aerosolized Mist Evaporation Rate: Faster than Ether
Solubility in Water: Slight Freeze Point: N.D.
Specific Gravity: 0.736 pH: N.A.
Physical State: Liquid
(See section 16 for abbreviation legend)
10. Stability and Reactivity
CONDITIONS TO AVOID: Flammable hydrogen gas will evolve when product comes in contact with water or damp air. Heat will be
generated. The amount of heat generated will depend upon the volume of material in contact. Avoid temperatures above 120 ° F.
Avoid contact with strong acid and strong bases. Avoid all possible sources of ignition.
INCOMPATIBILITY: Incompatible with strong oxidizing agents, strong acids and strong alkalies.
HAZARDOUS DECOMPOSITION: By open flame, carbon monoxide and carbon dioxide. When heated to decomposition, it emits
acrid smoke and irritating fumes. Contains solvents which may form carbon monoxide, carbon dioxide, and formaldehyde.
HAZARDOUS POLYMERIZATION: Will not occur under normal conditions.
STABILITY: This product is stable under normal storage conditions.
11. Toxicological Information
Chemical Name LD50 LC50
Liquefied Petroleum Gas N.E. N.E.
Acetone 5800 mg/kg (Rat) 50100 mg/m3 (Rat, 8Hr)
n-Butyl Acetate 13100 mg/kg (Rat, Oral) 2000 ppm (Rat, Inhalation, 4Hr)
Mineral Spirits >5000 mg/kg (Rat, Oral) >5.28 mg/L( Rat, Inhalation, 4 hr)
Naphtha, Petroleum, Hydrotreated Light N.E. N.E.
Xylene (mixed isomers) 4300 mg/kg (Rat, Oral) 5000 ppm (Rat, Inhalation, 4Hr)
Stoddard Solvent >5000 mg/kg (Rat, Oral) 21 mg/L (Rat, Inhalation, 1 hr)
1-Methoxy-2-propyl acetate 8532 mg/kg (Oral, Rat) >4345 ppm (Inhalation, Rat, 6 hr)
Aluminum Flake >2000 mg/kg (Rat, Oral) 7.6 mg/L (Rat, Inhalation)
Page 3 / 6