Use and Care Manual
TECHNICAL DATA ROC-45
ROOF ACCESSORY PAINT
Form: GDH-671
Rev.: 012815
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Roof Accessory Paint creates a durable, weather-
resistant finish that can be applied to stacks, vents and other roof
penetrations. Roof Accessory Paint protects and complements a
variety of roof accessories. It is suitable for application to wood,
metal, masonry and plastic. Not for use on galvanized steel.
.PRODUCTS .
SKU (12 ounces) Description
285217 Weathered Wood
285222 Rustic Slate
285223 Dark Gray
285225 Shakewood
285227 Carbon Black
286117 Espresso Shake
..PRODUCT APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when the temperature is between 50-90°F
(10-32°C) and humidity is below 85% to ensure proper
drying. Do not apply to surfaces that will exceed 200°F
(93°C) or on galvanized metal. Avoid spraying in very
windy, dusty conditions. Cover surrounding area to protect
from spray mist.
SURFACE PREPARATION
Remove all dirt, grease, oil, and chemical contaminants by
washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow
to thoroughly dry. Remove loose paint and rust with a wire
brush or sandpaper. Lightly sand glossy surfaces.
WARNING! If you scrape, sand or remove old paint from
any surface, you may release lead paint dust. LEAD IS
TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE
SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE;
ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH
approved respirator to control lead exposure. Clean up
carefully with a HEPA vacuum and a wet mop. Before you
start, find out how to protect yourself and your family by
contacting the National Lead Information Hotline at 1-800-
424-LEAD or log on to www.epa.gov/lead.
..PRODUCT APPLICATION .
APPLICATION
Shake can vigorously for one minute after mixing ball
begins to rattle. If mixing ball fails to rattle, DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold the can upright 10-16” from the surface and
spray in a steady back-and-forth motion, slightly
overlapping each stroke. Keep the can the same distance
from the surface and keep the can in motion while
spraying. Apply 2 or more light coats a few minutes apart.
DRY & RECOAT TIMES
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Dries to the touch in 20 minutes, to
handle in 1 hour and is fully dry in 24 hours. Apply a
second coat or clear coat within 1 hour or after 48 hours.
Apply a clear coat in 2-3 light coats a few minutes apart.
NOTE: On plastic, maximum paint adhesion and durability
is achieved in 5-7 days.
CLEAN-UP
Wipe off tip before storing. Clean up wet paint with xylene
or mineral spirits. Properly discard of empty container. Do
not burn or place in home trash compactor.
CLOGGING
If valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not stick pin or other
object into the stem.