Use and Care Manual

TECHNICAL DATA
ROC-72
ROOF ACCESSORY COATING
1
Form: GDH-1173
Rev.:092123
DESCRIPTION AND USES
Rust-Oleum
®
Roof Accessory Coating creates a durable,
weather-resistant finish that can be applied to stacks, vents
and other roof penetrations. Roof Accessory Coating
protects and matches a variety of roof accessories and can e
applied to wood, metal, masonry and plastic.
NOTE: Not for use on galvanized steel.
PRODUCT FEATURES
•
Protects and matches roof accessories
•
Adheres to metal, plastic, masonry and wood
• Durable weather resistant finish
PRODUCTS
SKU
DESCRIPTION (12 Oz. Aerosol)
285217
Weathered Wood
285222
Rustic Brown
302123
Dark Gray
285225
Shakewood
302125
Espresso Brown
285227
Carbon Black
313815
Red Tile
314061
Cedar
383418
Desert Tan
383416
Slate Gray
383419
Forest Green
383420
Blizzard White
PRODUCT APPLICATION
SURFACE PREPARATION
Remove all dirt, grease, oil, and chemical contaminants by
washing the surface with a commercial detergent, or other
suitable cleaning method. Rinse with fresh water and allow
to thoroughly dry. Remove loose paint and rust with a wire
brush or sandpaper. Lightly sand glossy surfaces.
WARNING! If you scrape, sand or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS
BRAIN DAMAGE, ESPECIALLY IN YOUNG CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE.
Wear a NIOSH-approved respirator to control lead exposure.
Clean up carefully with a HEPA vacuum and a wet mop.
Before you start, find out how to protect yourself and your
family by contacting the National Lead Information Hotline at
1-800-424-LEAD or log on to www.epa.gov/lead.
PRODUCT APPLICATION (cont.)
APPLICATION
Use outdoors or in a well ventilated area such as an open
garage. Use when the temperature is between 50-90°F
(10-32°C) and humidity is below 65% to ensure proper drying.
Do not apply to surfaces that, when heated, exceed 200°F
(93°C) or on galvanized metal. Avoid spraying in very windy,
dusty conditions. Cover surrounding area to protect from
spray mist.
Shake can vigorously for one minute after mixing ball begins
to rattle. If mixing ball fails to rattle, DO NOT STRIKE CAN.
Contact Rust-Oleum. Shake often during use. Hold the can
upright 10-16” from the surface and spray in a steady back-
and-forth motion, slightly overlapping each stroke. Keep the
can the same distance from the surface and keep the can in
motion while spraying. Apply 2 or more light coats a few
minutes apart.
DRY & RECOAT TIMES
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Dries to the touch in 20 minutes, to handle
in 1 hour and is fully dry in 24 hours. Apply a second coat or
clear coat within 1 hour or after 48 hours. Apply a clear coat in
2-3 light coats a few minutes apart.
NOTE: On plastic, maximum paint adhesion and durability is
achieved in 5-7 days.
CLEAN-UP
When finished spraying, wipe off tip before storing. Clean up
wet paint with xylene or mineral spirits. Dispose of empty can
in recycle pickup. Do not burn or place in home trash
compactor.
CLOGGING
If valve clogs, twist and pull off spray tip and rinse in a solvent
such as mineral spirits. Do not stick pin or other object into
the stem.