Use and Care Manual

TECHNICAL DATA
STOPS RUST
®
MATTE CLEAR ENAMEL
Rust-Oleum Corporation Form: GDH-664
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 041817
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
MATTE CLEAR ENAMEL
Resin Type
Acrylic
Pigment Type
Amorphous Silica
Solvents
Acetone, Toluene, Xylene
MIR
0.85 Max
Fill Weight
12 ounces
Recommended Dry Film
Thickness (DFT) Per Coat
1.0-1.5 mils
(25-37.5µ)
Practical Coverage
at Recommended DFT
8-10 sq.ft./can
(0.74-0.93 m
2
/can)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
5 minutes
Handle
20 minutes
Recoat
Any time
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
-156°F (-104°C)
Safety Information
For additional information, see SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.