Specification

TECHNICAL DATA SRT-32
STOPS RUST
®
MATTE CLEAR ENAMEL
Form: GDH-664
Rev.: 050415
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Stops Rust
®
Matte Clear Enamel is an excellent
protective clear coating that resists corrosion, tarnishing and
chipping.
Stops Rust Matte Clear Enamel features an advanced spray
system that allows you to spray at any angle, even upside down
for those hard to reach areas. A comfort spray tip with a wider
finger pad reduces fatigue caused by continuous spraying.
.PRODUCTS .
SKU (12 ounce spray) Description
285093 Matte Clear Enamel
..PRODUCT APPLICATION .
READ ALL DIRECTIONS BEFORE BEGINNING
PROJECT.
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50 and 90°F
(10 and 32°C) and humidity is below 65% to ensure proper
drying. Do not apply to surfaces that, when heated,
exceed 200°F (93°C). Avoid spraying in very windy and
dusty conditions. Cover surrounding area to protect from
spray mist.
SURFACE PREPARATION
Wash the surface with a commercial detergent, or other
suitable cleaning method to remove dirt. Rinse with fresh
water and let dry. Remove loose paint and rust with a wire
brush or sandpaper. Clean concrete surfaces with a
suitable cleaner and water. Rinse and allow to dry. Lightly
sand glossy surfaces.
WARNING: If you scrape, sand, or remove old paint, you may
release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD
DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN
DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN
SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved
respirator to control lead exposure. Clean up carefully with a
HEPA vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National Lead
Information Hotline at 1-800-424-LEAD or log on to
www.eps.gov/lead.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can 6-8" from surface and spray in a steady
back-and-forth motion, slightly overlapping each stroke.
Keep the can the same distance from the surface and in
motion while spraying. Apply 2 or more light coats a few
minutes apart. For best results, apply multiple light coats
versus applying one heavy coat. Do not use near open
flame.
DRY & RECOAT
Dry and recoat times are based on 70°F (21°C) and 50%
relative humidity. Allow more time at cooler temperatures.
Dries to the touch in 5 minutes, to handle in 20 minutes.
May recoat at anytime. Do not apply Clear Enamel over
Stops Rust Bright Coat Finish or Aluminum Finish.
CLEAN-UP
Wipe off tip when finished. Clean up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.