Use and Care Manual

TECHNICAL DATA
LEAKSEAL
TM
SELF-FUSING SILICONE TAPE
Rust-Oleum Corporation Form: GDH-126
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 072613
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
LEAKSEAL SELF-FUSING SILICONE TAPE
OPERATING TEMPERATURE RANGE CONTINUOUS
-50°F to 400°F (-45°C to 200°C)
OPERATING TEMPERATURE RANGE INTERMITTENT
-80°F to 500°F (-65°C to 260°C)
SPECIFIC GRAVITY
1.20 ± 0.03
SHORE A DUROMETER HARDNESS (Room Cured – 24 hours)
55 ± 5
TENSILE STRENGTH
700 psi min
ELONGATION
300% min
TEAR STRENGTH
60 ppi min
BOND STRENGTH
2 lbs. min
ADHESION, unwind
3 in. min
COLD BRITTLE POINT
-65°F (-54°C)
WATER ABSORPTION (by weight)
5% max
DIELECTRIC STRENGTH
400Vpm min
DIELECTRIC CONSTANT, 1kH3
2.95
DISSIPATION FACTOR, 1kH3
<0.0004
VOLUME RESISTIVITY
1 x 10
13
OHMs/cm
SAFETY INFORMATION
For additional information, see MSDS.
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.