Use and Care Manual

TECHNICAL DATA
STOPS RUST
®
LEAKSEAL
®
BRUSH
Rust-Oleum Corporation Form: GDH-321
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 012815
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company⅗
PHYSICAL PROPERTIES .
LEAKSEAL BRUSH
Resin Type
Synthetic Rubber
Pigment Type
Carbon Black, Silica
Solvents
N-Butyl Acetate, VM&P Naphtha
Weight
Per Gallon
7.12-7.16 lbs.
Per Liter
1.88-1.89 kg
Solids
By Weight
23.8-26.9%
By Volume
23.4-26.0%
Volatile Organic Compounds
<640 g/l (5.32 lbs./gal.)
Recommended Dry Film Thickness
(DFT) Per Coat
2-4 mils
(50-100µ)
Wet Film to Achieve DFT
8-16 mils
(200-400µ)
Theoretical Coverage at
1 mil DFT (25µ)
94-96 sq.ft./quart
(2.31-2.36 m
2
/l)
Practical Coverage at Recommended
DFT
20-40 sq.ft./quart
(0.5-1.0 m
2
/l)
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Touch
1 hour
Recoat
30 minutes to 1 hour
Fully Dry
After 24 hours
Shelf Life
5 years
Flash Point
10°C (50°F)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.