Use and Care Manual

TECHNICAL DATA SRT-17
LEAKSEAL
TM
FLEXIBLE SEALER
Form: CS2008
Rev.: 012313
1
.DESCRIPTION AND USES .
Rust-Oleum
®
LeakSeal
™
is an easy to use, rubberized
protective utility coating designed to fill and seal leaks and
cracks. It provides a water-tight, flexible seal that prevents
moisture penetration and corrosion. LeakSeal dries to a semi-
smooth finish that will not sag or drip, and can be top-coated
with latex or oil-based paints. This product is designed for
use on metal, aluminum, galvanized metal, PVC, concrete,
masonry, asphalt roofing materials, vinyl siding, fiberglass,
and more.
.PRODUCTS .
SKU Description
265494 LeakSeal Black
265495 LeakSeal Clear
267970 LeakSeal White
267972 LeakSeal Aluminum
267976 LeakSeal Brown
..PRODUCT APPLICATION .
SURFACE PREPARATION
Remove all dirt and debris from the area to be coated. Wash
area with a detergent and water solution, rinse with fresh
water, and allow the surface to dry thoroughly. Remove any
loose paint or previous coatings with a wire brush or
sandpaper. Lightly sand glossy surfaces. Wipe the sanded
surface clean when finished.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Use outdoors or in a well ventilated area such as an open
garage. Apply when temperature is between 50°F and 90ºF
(10-32ºC) and humidity is below 85% to ensure proper drying.
Do not apply to surfaces, when heated, exceed 200ºF (93ºC).
Avoid spraying in very windy and dusty conditions. Cover
surrounding area to protect from spray mist.
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT STRIKE
CAN. Contact Rust-Oleum. A test spray on cardboard is
recommended to obtain feel for the spray pattern. Hold can 8-
18” from the surface and spray in short even strokes. It is
recommended to apply a light first coat. Apply a second
heavier coat to ensure proper coverage. A thicker film can be
achieved by moving the nozzle closer to the surface. Initial
spray may have some foaming or bubbling, but will dissipate
as the coating dries. For best results, apply 2 coats. Allow to
dry 15-30 minutes between coats.
LeakSeal can be top-coated with water-based or oil-based
paints after 24 hours.
DRY & RECOAT
Dry and recoat times are based on 70ºF and 50% relative
humidity. Allow more time at cooler temperatures. Dries to the
touch in 20-30 minutes, to handle in 45-60 minutes, and can
be re-coated with itself in 20-30 minutes. Allow 24 hours for
full cure.
CLEAN-UP
Wipe off tip when finished. Clean-up wet paint with xylene or
mineral spirits. Properly discard empty container. Do not
burn or place in home trash compactor.
CLOGGING
I
f the valve clogs, twist and pull off spray tip and rinse in a solvent
such as mineral spirits. Do not insert any object into can valve
opening.