Use and Care Manual
TECHNICAL DATA SRT-04
STOPS RUST
SATIN BRUSH
Form: CS2157
Rev.: 022713
1
.DESCRIPTION AND USES .
Rust-Oleum
®
Stops Rust
®
Satin Finish provides a classic low
sheen and durable finish. This smooth, protective enamel offers
excellent coverage, chip resistance and color retention. Use on
interior/exterior metal or wood surfaces. For even longer, lasting
protection, use a Stops Rust
®
primer first. Not for use on
galvanized steel.
.PRODUCTS .
SKU (1-Quart) Description
242110 Dark Olive
242111 Dark Taupe
242112 Old Brick
242113 Dark Brown
7732502 Hunter Green
7767502 Redwood
7774502 Chestnut Brown
7777502 Black
7791502 White
7793502 Shell White
..PRODUCT APPLICATION .
PAINTING CONDITIONS
Apply only when air and surface temperatures are
between 50-90°F (10-32°C) and humidity is below 85% to
ensure proper drying. Do not apply to surfaces that will
exceed 200°F (93°C). Do not use on galvanized steel.
SURFACE PREPARATION
ALL SURFACES: Remove all dirt, grease, oil, salt and
chemical contaminants by washing the surface with a
commercial detergent or other suitable cleaning method.
Rinse thoroughly with fresh water and allow to fully dry. All
surfaces must be dry at time of application.
STEEL: Scrape and wire brush or power tool clean to
remove loose rust, scale and deteriorated previous
coatings. Use 7769 Rusty Primer for sound rusted or clean
metal before application of a finish coat. 7780 White Clean
Primer is best for clean metal but may be used on sound
rusted metal as well.
..PRODUCT APPLICATION (cont.) .
PREVIOUSLY COATED: Previously coated surfaces must
be sound and in good condition. Smooth, hard, or glossy
finishes should be scarified by sanding to create a surface
profile. The Stops Rust Satin Finish is compatible with
most coatings, but a test patch is suggested. WARNING! If
you scrape, sand or remove old paint from any surface,
you may release lead paint dust. LEAD IS TOXIC.
EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS
ILLNESS, SUCH AS BRAIN DAMAGE; ESPECIALLY IN
CHILDREN. PREGNANT WOMEN SHOULD ALSO
AVOID EXPOSURE. Wear a NIOSH approved respirator
to control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.epa.gov/lead.
APPLICATION
Before using, stir thoroughly to ensure any settled pigment
is re-dispersed. If necessary, thin the material with
acetone. For brush or roller, thinning is not normally
required. For air spray, thin up to 15% with acetone. Do
not thin with gasoline, lacquer thinner, turpentine, etc. For
airless spray, thinning is not normally required. Apply with
a good quality brush, roller or spray gun.
Brush: Use light, even strokes. Excessive brushing
reduces film thickness and protection.
Roller: A 3/8" nap roller should be used on rough surfaces.
Cover approximately one square yard at a time. Roll away
from previously coated area and work back to it for a
uniform appearance. Use a brush on crevices and sharp
edges.
Spray Gun: Follow spray gun directions carefully. Always
keep the gun ten to twelve inches from the surface and in
motion while spraying.
CLEAN-UP
Clean brush and tools with Mineral Spirits.