Use and Care Manual

TECHNICAL DATA
STOPS RUST HAMMERED BRUSH
Rust-Oleum Corporation Form: CS2163
11 Hawthorn Parkway Phone: 877•385•8155 Rev.: 022813
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company⅗
PHYSICAL PROPERTIES .
STOPS RUST HAMMERED BRUSH
Resin Type
Modified alkyd
Pigment Type
Varies with color
Solvents
Aromatic Hydrocarbons
Weight
Per Gallon
7.6-7.8 lbs
Per Liter
0.9-0.93 kg
Solids
By Weight
51.5-52.5%
By Volume
44.5-45.5%
Volatile Organic Compounds
<450 g/l
(3.75 lbs./gal.)
Recommended Dry Film
Thickness (DFT) Per Coat
1.0-2.0 mils
(25-50µ)
Wet Film to Achieve DFT
2.0-4.0 mils
(50-100µ)
Theoretical Coverage at
1 mil DFT (25µ)
178-182 sq.ft./qt.
(17.5-17.9 m
2
/l)
Practical Coverage at Recommended
DFT
75-150 sq.ft./qt.
(7.4-14.8 m
2
/l)
Dry Times at
70°F (21°C) and
50% Relative
Humidity
Touch
30 minutes
Handle
60-90 minutes
Recoat
Within 4 hours or after 7 days
Dry Heat Resistance
200°F (93°C)
Shelf Life
5 years
Flash Point
52°F (11°C)
Safety Information
For additional information, see MSDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.