SDS

Date Printed: 11/15/2016
UNUSUAL FIRE AND EXPLOSION HAZARDS: FLASH POINT IS LESS THAN 20°F. EXTREMELY FLAMMABLE LIQUID AND
VAPOR!Water spray may be ineffective. Closed containers may explode when exposed to extreme heat. Vapors may form
explosive mixtures with air. Vapors can travel to a source of ignition and flash back. Keep containers tightly closed. Isolate from
heat, electrical equipment, sparks and open flame. Perforation of the pressurized container may cause bursting of the can. Closed
containers may explode when exposed to extreme heat due to buildup of steam. No unusual fire or explosion hazards noted.
SPECIAL FIREFIGHTING PROCEDURES: Evacuate area and fight fire from a safe distance. Full protective equipment including
self-contained breathing apparatus should be used. Water may be used to cool closed containers to prevent pressure buildup and
possible autoignition or explosion. Use water spray to keep fire-exposed containers cool. Containers may explode when heated.
6. Accidental Release Measures
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: Contain spilled liquid with sand or earth. DO NOT use
combustible materials such as sawdust. Remove all sources of ignition, ventilate area and remove with inert absorbent and non-
sparking tools. Dispose of according to local, state (provincial) and federal regulations. Do not incinerate closed containers. Isolate
the hazard area and deny entry to unnecessary and unprotected personnel. Ventilate area, isolate spilled material, and remove with
inert absorbent. Dispose of contaminated absorbent, container, and unused contents in accordance with local, state, and federal
regulations.
7. Handling and Storage
HANDLING: Wash thoroughly after handling. Wash hands before eating. Use only in a well-ventilated area. Follow all MSDS/label
precautions even after container is emptied because it may retain product residues. Avoid breathing fumes, vapors, or mist.
Remove contaminated clothing and launder before reuse. Use only with adequate ventilation. Avoid contact with eyes, skin and
clothing.
STORAGE: Keep containers tightly closed. Isolate from heat, electrical equipment, sparks and open flame. Contents under
pressure. Do not store above 120 ° F. Store large quantities in buildings designed and protected for storage of NFPA Class I
flammable liquids. Contents under pressure. Do not expose to heat or store above 120 ° F. Product should be stored in tightly
sealed containers and protected from heat, moisture, and foreign materials. Store in a dry, well ventilated place. Keep container
tightly closed when not in use. Keep away from heat, sparks, flame and sources of ignition. Avoid excess heat.
8. Exposure Controls/Personal Protection
Chemical Name CAS-No.
Weight %
Less Than
ACGIH TLV-
TWA
ACGIH TLV-
STEL
OSHA PEL-
TWA
OSHA PEL-
CEILING
Acetone 67-64-1 20.0 250 ppm 500 ppm 1000 ppm N.E.
Propane 74-98-6 20.0 N.E. N.E. 1000 ppm N.E.
n-Butyl Acetate 123-86-4 15.0 50 ppm 150 ppm 150 ppm N.E.
n-Butane 106-97-8 10.0 N.E. 1000 ppm N.E. N.E.
Barium Sulfate 7727-43-7 10.0 5 mg/m3 N.E. 15 mg/m3 N.E.
Dimethyl Carbonate 616-38-6 10.0 N.E. N.E. N.E. N.E.
Naphtha, Petroleum,
Hydrotreated Light
64742-49-0 5.0 N.E. N.E. N.E. N.E.
Xylenes (o-, m-, p- isomers) 1330-20-7 5.0 100 ppm 150 ppm 100 ppm N.E.
Ethylbenzene 100-41-4 5.0 20 ppm N.E. 100 ppm N.E.
Carbon Black 1333-86-4 5.0 3 mg/m3 N.E. 3.5 mg/m3 N.E.
Titanium Dioxide 13463-67-7 1.0 10 mg/m3 N.E. 15 mg/m3 N.E.
Stoddard Solvent 8052-41-3 1.0 100 ppm N.E. 500 ppm N.E.
PERSONAL PROTECTION
ENGINEERING CONTROLS: Use process enclosures, local exhaust ventilation, or other engineering controls to control airborne
levels below recommended exposure limits. Use explosion-proof ventilation equipment. Prevent build-up of vapors by opening all
doors and windows to achieve cross-ventilation. Provide general dilution of local exhaust ventilation in volume and pattern to keep
TLV of hazardous ingredients below acceptable limits.
RESPIRATORY PROTECTION: A respiratory protection program that meets OSHA 1910.134 and ANSI Z88.2 requirements must
be followed whenever workplace conditions warrant a respirator's use. A NIOSH/MSHA approved air purifying respirator with
organic vapor cartridge or canister may be permissible under certain circumstances where airborne concentrations are expected to
exceed exposure limits.
SKIN PROTECTION: Use impervious gloves to prevent skin contact and absorption of this material through the skin. Nitrile or
Neoprene gloves may afford adequate skin protection. Use gloves to prevent prolonged skin contact.
EYE PROTECTION: Use safety eyewear designed to protect against splash of liquids.
OTHER PROTECTIVE EQUIPMENT: Refer to safety supervisor or industrial hygienist for further information regarding personal
protective equipment and its application. Refer to safety supervisor or industrial hygienist for further guidance regarding types of
personal protective equipment and their applications.
Page 3 / 6